The telescopic belt conveyor belt machine maintenance and maintenance

V belt, chain transmission and coupling to set up the shield. Its position and fixed way to consider when maintenance is easy to move all of the open air conveying confidential cover cover. This kind of outer garment is made from 16 corrugated galvanized steel sheet, in order to protect the conveyor and material is not affected by bad weather conditions. Housing can be made into arch, splicing, open to facilitate the inspection.

Each conveyor head the roller are equipped with strong springs of rod and compound rubber scraper. In this position can make sweeping down from the Belt Conveyor surface material could fall into the unloading chute.

Empty section sweeper for plough plate, put in front of the vertical tension device and the tail in the front of the platen backhaul conveyor belt. Each moldboard is equipped with a safety chain in order to prevent the one thousand accident moldboard moving with the Belt Conveyor.

When the conveyor multipoint discharge along the way, can use electric mobile CheWu discharger discharge. Discharge groove and discharge position must carry on the design, also need the relevant design data, flow chart of equipment to attach on this part of the technical requirements.

When the horizontal conveyor need to dump in the middle, can use plough tripper. On the design flow chart of data or attached to show that the type of moldboard used, discharge conditions and indicate the unilateral or bilateral discharging.

The Angle of the tripper plough moldboard will be limited to 35 degrees. All equipped with adjustable moldboard rubber scraper; Under the moldboard is equipped with a wide metal plate bracket with conveyor belt conveyor belt.

Into Angle to load the material in the conveyor belt running direction will only add to wear on the surface of the tape. The impact on the tape, deviating from the center of the raw material, can make the belt along the roller to the other side of the rotating up and running deviation, can lead to damage of tape and glue, and local side adhesive wear. Than the big, sharp edges and materials, to produce certain impact on fast run tape or sliding, also will be cut and the wear surface. General method is to reduce the wear, first put powder material on the tape, then load the big materials, powder material is to play the role of a cushion, thereby protecting the tape.

Unloading plough plate can be controlled by compressed air or gravity lever lifting. When operating conditions for mobile unloading plough plate, can be installed on the plow tripper rope and the winch, the plough wu discharger fixed position in each discharge.

All discharge funnel are made of the steel plate. The minimum thickness of 6 mm, can be properly strengthened. And using solid support bearing. In the upper part of the funnel discharge the roller edge width is smallest conveyor belt width and 230 mm, in order to prevent damage to the conveyor belt.